Vui lòng dùng định danh này để trích dẫn hoặc liên kết đến tài liệu này: http://thuvienso.vanlanguni.edu.vn/handle/Vanlang_TV/20495
Nhan đề: Vibration Failure of Young Low-Temperature Concrete Shaft Linings Caused by Blasting Excavation
Tác giả: Xie, Lidong
Dong, Zhaoxing
Qi, Yanjun
Qiu, Ruohua
He, Qiang
Từ khoá: Vibration Failure
Blasting Excavation
Concrete Shaft
Civil Engineering
Năm xuất bản: 2019
Nhà xuất bản: Hindawi Limited
Tóm tắt: The freezing-blasting method constitutes the only available technique for excavating mining shafts within water-bearing bedrock. This study explores the effects of vibration damage to young C65 concrete shaft linings caused by close-range blasting excavation using the finite element method. C65 concrete test specimens were made in the laboratory and then cured at −7°C, and the elastic modulus, compressive strength, and longitudinal wave velocity were tested. The allowable dynamic tensile strength of the concrete for each mold of the shaft lining was obtained according to the observed strain rate of the concrete shaft lining using a regression formula. The finite element simulation results are basically consistent with the in situ measurements, thereby attesting to the validity of the numerical simulation. The blasting-induced vertical peak vibration velocity of the first mold of the concrete shaft lining reached 20∼25 cm/s, which far surpasses the allowable vibration velocity range (i.e., 2∼3 cm/s) in the Safety Regulations for Blasting for newly cast concrete between the initial setting and an age of 3 d. The tensile stress of the first concrete mold calculated by the finite element method is approximately equal to the theoretical tensile stress, both of which are smaller than the dynamic tensile strength of concrete. The cumulative energy sustained by the shaft lining of each mold and the allowable values of the dynamic tensile strength were obtained. The growth rate of the dynamic tensile strength of the subsequent molds was larger than that of the cumulative energy, and thus the safety of the shaft lining gradually improved. The C65 concrete would therefore not experience tensile failure after the shaft lining has sustained multiple rounds of blasting loads. This finding can provide a basis for safety considerations when employing the freezing-blasting method to construct mining shafts in water-bearing bedrock.
Mô tả: Hindawi Advances in Civil Engineering Volume 2019, Article ID 5343618, 10 pages https://doi.org/10.1155/2019/5343618
Định danh: http://thuvienso.vanlanguni.edu.vn/handle/Vanlang_TV/20495
ISSN: 1687-8086
1687-8094 (eISSN)
Bộ sưu tập: Bài báo_lưu trữ

Các tập tin trong tài liệu này:
Tập tin Mô tả Kích thước Định dạng  
BBKH1676_TCCN_Vibration Failure of Young.pdf
  Giới hạn truy cập
Vibration Failure of Young Low-Temperature Concrete Shaft Linings Caused by Blasting Excavation1.64 MBAdobe PDFXem/Tải về  Yêu cầu tài liệu


Khi sử dụng các tài liệu trong Thư viện số phải tuân thủ Luật bản quyền.